Pool Party flowers

1.  stamped flowers on pool party with versa mark stamp pad, added white embossing powder and heat set.
2.  Used the fine tip end of the pool party marker to trace inside each petal next to the embossing - since it is raised it is easy to stay inside the petals.
3.  ran to top of this piece that is empty through the big shot with the fancy fan embossing folder
4.  added the black ribbon to front and taped on the back. 
5.  added the tie to the front, I wanted the ribbon to fall on the opposite side of the card than the flowers so I acutally layed the ribbon from the top left corner down over the flowers then tied and the ribbon layed opposite from how it was originally.
6.  Layered onto a piece of basic black card stock cut just an 1/8 th of an inch bigger than the pool party piece;  I just love this very little layer!!!
7. Mounted all onto whisper white

 Close up on flowers;